Broken connections
When writing a value would make Revit re-check a pipe or fitting it already flags as badly connected, Revit would disconnect it and split its system. The Executor sets such elements aside and asks once, before the report.
When it appears
During a run, only when the run met such elements.
What's in it
| Button | What it does |
|---|---|
| Show elements | Selects them in Revit, so you can look before deciding |
| Write anyway | Writes them — and Revit disconnects them |
| Skip this element / Skip these N | Leaves them as they are; they appear in the report as Broken connection in the model. Closing the question counts as Skip |
The problem was in the model before the run; fix the connections and run again.